New V-20 project

[Curapa]

I did a little work on the console this morning. I ripped down some 2x's for the inside corners. Since I'm running the 1 1/2" router bit around the edges, I needed some more meat to rout. The angled corners will make it easy to glass on the inside as well, not to mention the stability added. I glued them in and added some screws until it set.

[Curapa]

I removed the screws and got the inside tabbed together. I left the face off so I can glass the inside easier. I plan to glass most of the inside, put on the front, finish glassing the inside, then rout the outside edges and begin working on the outside.