Mercruiser Start Up/Marvel's Oil

[smokeonthewater]

1/2" is the size of ratchet or breaker bar that fits it... If it was the sbc socket then it will work.

[smokeonthewater]

Don't worry about mice... Just get oil in there and work it back and forth

[Tunnaman88]

I purchased the one smokeonthewater said to http://m.summitracing.com/parts/pro-...FQwvaQodUj0AeQ

I put trust into you guys, so I just ordered it in the effort to move forward... cylinders should be nice and lubed by the time summit ships it out...I have to get a puller to take off the Balancer too.... thinkin about the cheapo puller kit at harbor freight? ... will it work?

http://www.harborfreight.com/bolt-ty...set-69889.html

going out to work on the pig now

[smokeonthewater]

Go to Oriley or autozone... You can rent one for free.... You pay a deposit and then get the deposit back when you return the tool.

[smokeonthewater]

Yeah that's the one... You're GTG

[Tunnaman88]

It only cost $28.00 shipped... it would cost almost that in gas and of McD's while Im out! LOL

[Tunnaman88]

IMG_0788.jpg

IMG_0791.jpgGot out there and the freed up nicely.. was able to pull all the plugs one at a time and load them up with tranny fluid.. here is a laugh..
I used a ball primer to get the oil into the cylinders, the second one I did was #3.. I pumped and pumped and it didn't take much.. I pulled the hose away and tranny fluid shot out like a musket gun and got me right in the eye!! LOL... effin rookie!!! I did notice that # 3 #4 ? the two middle ones ... the pugs were real funky.. some sort of green mold growin on them.. any thoughts?? I plan on letting this sit until Saturday before trying to budge it.. that will give it 4 days.. for the most part..engine looks pretty new/clean