Transom repair

[SkunkBoat]

yesterday was slow going. Tried to remove the remains of the wood from the edges using the auger bit and a tiny flat bar. Wasted most of a day before making the move to the chain saw. I had bought a 14" electric at Harbor Freight (under $50) just in case but I was kind of afraid to try it.

GREATEST THING SINCE SLICED BREAD!!!!!!

Of course, you do have to be careful (said the guy using a chain saw for an unintended purpose).

Starboard side was super easy because of the angle. Port side got pretty awkward toward the top because you had to be sort of upside-down. Still way faster than my other method. You would be surprised how the side of the chain rides along the fiberglass.

[bradford]

Sweet!

[SkunkBoat]

OK! Poured the transom today!

Working on a video of the full project but here are some pics.

Had a problem but turned out ok.

In pics, watch the drain hole on the stringer. There were small holes between the transom & the bottoms of the stringers (plural) that I did not forsee.

Luckily paper towels stopped it up quick. Only lost about a pint into the bilge area.

2 buckets (10 Gal) reached to about 3 inches below the transom cutout.

It cooked for a couple hours. Solid as a rock now.

I will glass over the cutout and pour the rest tomorrow.

[bradford]

Looking forward to the video.

[Striper80]

Looking good. I'm getting ready to cut into mine in a few weeks.

[captpete13]

Looking good. Are you coming back to Garden State when it's all back together?

[bgreene]

Good for you - doing it yourself, likely learned a lot, saved $$ and will be proud of the job.

[SkunkBoat]

Originally Posted by captpete13

Looking good. Are you coming back to Garden State when it's all back together?

yes, paid for the slip already so I would be motivated!