Help me find a motor...

[THEFERMANATOR]

If you need a 20" shaft engine, watch screamandfly.com. Theres always good freshwater 20" shaft engines going up for sale over there. If you're on a budget, I would go with a 2.0L carbed 150 MERC. OPTI's are nice for fuel economy, but when a compressor goes, it's a $100 bill last I checked. My 2nd choice would be one of the 2.6L 150 YAMAHA's. It's a TOUGH engine with a PROVEn track record. Also decent on fuel with fair power. Theres alot of good engines out there, but finding one that isn't going to drink you out of house and home buying on a budget will be a challenge.

[Monkey Butler]

I have a 1986 V-6 Special that needs to be put together. Powerhead is in one piece. Located in Mass. Any interest?

[smokeonthewater]

Possibly, 20" shaft? Why is it apart?

[Monkey Butler]

25" shaft. It's the one on the boat in my sig. I found a newer 1991 that I now use.

I was going to replace the shift rod which turned out to be in good shape. Have most new gaskets, and a new exhaust adapter and tuner. Needs a tilt tube and it should have the lower resealed.

I'm thinking around $500

I'm also selling my Wellcraft 250 with a 1991 225hp and tandem trailer with brakes. I was going to wait til the weather warmed up to do clean it up and list it for more but pre-season to V20'ers is $3500

[bgreene]

Get on the phone and call all the dealers closest to you branching outward ....

Hello - do you have any good used outboard motors for sale ?

Do that 100 times and chances are you'll find it.

[smokeonthewater]

Originally Posted by Monkey Butler

25" shaft. It's the one on the boat in my sig. I found a newer 1991 that I now use.

I was going to replace the shift rod which turned out to be in good shape. Have most new gaskets, and a new exhaust adapter and tuner. Needs a tilt tube and it should have the lower resealed.

I'm thinking around $500

Sounds like that might be a decent option.... Have you compression tested it? or can you?

Newer would be nice but if it's in good shape I could throw it together and man that ought to make a V20 scream.

I wonder if I can find a 20" mid section.... Might be able to use a jack plate... will have to look at the steering cable routing

[smokeonthewater]

Found a pic of the boat from the stern and a jack plate should be no problem at all.

temp.jpg

[smokeonthewater]

?