New to me toy.

[spareparts]

the place my wife works at is set up as a Honda dealer if you need anything. I'm not saying they have it in stock() but they can order it

[bradford]

You're gonna love the fuel mileage. My old 2 stroke Tohatsu 90 burned as much fuel as my ETEC with nearly half the horsepower, much lighter and more efficient hull, etc. Not to mention how loud the old ones sound after you get used to the newer ones.

Was looking at a 18 or 20 for mine, under the console. I want the fill directly on the tank and the fuel line on the same side to facilitate easy K.I.S.S. rigging. Also would prefer a translucent tank to be able to just look at it and know my fuel level. Do you have a model # for yours?

[THEFERMANATOR]

Originally Posted by bradford

You're gonna love the fuel mileage. My old 2 stroke Tohatsu 90 burned as much fuel as my ETEC with nearly half the horsepower, much lighter and more efficient hull, etc. Not to mention how loud the old ones sound after you get used to the newer ones.

Was looking at a 18 or 20 for mine, under the console. I want the fill directly on the tank and the fuel line on the same side to facilitate easy K.I.S.S. rigging. Also would prefer a translucent tank to be able to just look at it and know my fuel level. Do you have a model # for yours?

Well I lied, it's a 27 gallon tank. It is a translucent 27 gallon MOELLER tank with the filler on top, model FT2739. Mine has a hollow console with no storage or anything in it(all open underneath).

[bradford]

Originally Posted by THEFERMANATOR

Well I lied, it's a 27 gallon tank. It is a translucent 27 gallon MOELLER tank with the filler on top, model FT2739. Mine has a hollow console with no storage or anything in it(all open underneath).

Sweet! Thanks Ferm!

[Stinky_Hooker]

Thats nice Ferm! I bet she sees a lot of use!

[THEFERMANATOR]

Got to take it out today for a shakedown run to see how she does. 1st noticeable drawback is how quiet the HONDA is, now I can't use the excuse that the engine is to loud to hear the wife talking. 2nd drawback is I wish this one had EFI. I cleaned the carbs THOUROUGHLY to say teh least running tip cleaners through every jet, syncing em when I put em on, and setting the idle speed with a digital tach in the water. It runs great once your up to 1500RPM's or more, but at idle it MUST be trimmed in till the engine is level for it to run smooth. It will run smooth as silk with the engien level or trimmed in, but trim the engien up to go shallow and she starts coughing and shaking on me. Trim it back in and clear it out, and she goes back to purring like a kitten. My GPS only worked for a few minutes before my batteries died(no power outlet installed yet), but at 3800 she cruises comfortably and flat, and was running right around 22-23 MPH. I've got a 4 blade prop on order for it to try out as she wants to run bow high until I get it up in the speed(I'm sure that 400 pound HONDA hanging off the stern don't help), hoping it will lift the stern up a bit better at slower speeds. I have to also put a steering cable in it as it is pretty good at idle, but at speed it gets pretty stiff. Not looking forward to changing it as this is one you have to pull the outboard off to change the cable out.

Hoping to get to take her out for a shakedown feeshin trip this weekend. Hoping the spanish macks are still off the beach waiting for me.

[spareparts]

sounds like the float level might be a tad too high

[THEFERMANATOR]

Originally Posted by spareparts

sounds like the float level might be a tad too high

1 of them was, but I set them all. I was BEYOND paranoid going through these things this time around. This engine has ALWAYS been a PAIN to sync the carbs on, and get it to run right. Trimmed down she purrs like a kitten, starts right up when I hit the key, trim it up and she's another story.

[spareparts]

lean sneeze or flooding out?

[THEFERMANATOR]

Originally Posted by spareparts

lean sneeze or flooding out?

It acts like it's flooding out, but I can open up the idle screws a touch(you only have about an 1/8 turn of adjustment in them) and it doesn't do it as bad when trimmed up. But trim it down and it definately loads up. This engine has ALWAYS been a pain, just figured it goes with these carbs I have read so many horror stories about online. Why HONDA felt they needed a 4 circuit carb instead of just adding an accelerator pump is beyond me.