|
|
|
|
#1
|
|||
|
|||
Ah #%$*&! Looks like the shaft is frozen in the bearing so the outdrive won't just slide off.
Fun and games......
__________________
 i4110peter
|
|
#2
02-13-2015, 12:59 AM
|
||||
|
||||
|
The shaft sits inside the bearing on 2 orings, so it shouldn't be frozen to it. The outdrive is a bit tight to get out, but should come off. I've had to use a prybar to get em started before, just becareful prying against the bellhousing as they are actually pretty fragile.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#3
02-13-2015, 07:40 PM
|
||||
|
||||
|
you did put the shifter in forward gear before attempting to pull the drive, didn't You?
If its still stuck, set the trim cylinders about halfway out, turn the ends of the cylinders 90 degrees, raise the drive up and let it hit the trim pin against the cylinder ends, let it slam against them once or twice and the drive should com off
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
