|
|
|
|
#1
|
|||
|
|||
When I was looking to replace my back to back seat I did find one seat that had an extra tall base, I didnt get it because it was very expensive. I will see if I can find the brand for you.
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke. 
|
|
#2
12-19-2014, 11:10 AM
|
||||
|
||||
|
are you talking about bolting swivel seats back to back?
before i did that, i'd bolt one in and get a good deck chair to face to the stern. if you install a pedestal seat, through bolt it with fender washers on the underside. don't just lag it down.
|
|
#3
12-19-2014, 07:52 PM
|
||||
|
||||
|
Our V had a replacement back to back seat. It had a base built of 2x10 pressure treated lumber with a back to back seat attached to the top of the frame.
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;)
|
|
#4
12-20-2014, 07:25 AM
|
|||
|
|||
|
If your base is OK you could get just the seats from these guys and use your base.
http://veada.com/boat-lounge-seats/b...ts-ld200x.html Or you can order them with up to 18 inch tall base. http://veada.com/boat-lounge-seats/b...ats-ld200.html
__________________
*************************************** Stay Safe! Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke. Last edited by randlemanboater; 12-20-2014 at 07:37 AM.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
