|
|
#5
08-16-2014, 06:23 PM
|
||||
|
||||
Layed up layers of CSM until it was a little bit highNV Repower 018.jpg
NV Repower 019.jpg Waiting on this stuff to turn to plastic now....  Side note: If this looks like work, looks ain't deceiving.. Grinding always makes for itch, glassing is messy th way I do it.. If you look at the pictures you can see where I used the grinder to remove some gel coat from around the steering shaft. You can see where the builder left the surface fairly rough. Basically gel coat over matt after a quick wipe down.
__________________
 1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS Last edited by RidgeRunner; 08-16-2014 at 06:34 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode