|
|
|
|
#1
|
||||
|
||||
If it was a shift rod height adjustment, it would normally be hard to go into forward or reverse, not both normally. When in nuetral, the shift arm at the powerhead should be centered in it's travel. If it is the adjustment is correct. The other thing to look at for having trouble coming out of gear is teh shift interrupt switch. If it doesn't kill the engine during shifting, you have to move the shifter past center before it will pop out of gear.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#2
08-12-2014, 07:17 PM
|
||||
|
||||
|
I'll look at that tomorrow. I should mention that all my testing was done on land with the engine off. Also as of right now there is no interupter switch installed on my boat. I just ordered one and I will install it. Must've malfunctioned and the PO removed it.
I gave new shift cables but I'm hoping to hold off on installing them until over the winter when I clean up the rigging.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#3
08-12-2014, 09:25 PM
|
||||
|
||||
|
The shift interupter is part of the shift linkage on the engine. Without it the linkage would be REALLY sloppy, and I'm surprised you would be able to get it into gear at all.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664
|
|
#4
08-12-2014, 09:34 PM
|
||||
|
||||
|
The linkage is all still there. Only the switch itself isn't there. The linkage was actually extremely tight. Too tight infact, I had to sand the shaft with 1000 grit sandpaper and clean out the hole that the shaft rides in.
[URL=http://s1033. 
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
|
#5
08-15-2014, 09:31 PM
|
||||
|
||||
|
The shiftrod is set properly.tge engine shifts in and out of gear well. The only issue I have is to get to neutral I have to move the shifter about 1/8" past neutral to get it out of foreword. I'm going to take it out Sunday and see how it runs. I may change the cables this week and see if it works better.
__________________
1999 Wellcraft 22WA-200 Ocean Runner 1982 Grady White Tarpon 190-110 Evinrude-Sold 1996 Striper 2100WA-RIP Sandy 1989 Wellcraft 18-Sport-125 Force-sold
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
