need some guidance. stringers & transom

[brywheat]

Thanks

Awesome build by the way. So you used compsite board?

[tartuffe]

Thanks, was alot of fun. I only used composite core material on the deck and hatches. There is some pretty neat stuff out there that can used on a transom but I wasn't aware of them when I started in on my project.

[brywheat]

Tartuffe

For composite board dose it have to be infused vacuum bagged? Or whatever the proper terminology is? Doing research and it looks like awesome stuff. Did you start your rebuild onthe exterior of the hull? How did you flip it? Still have your support? Sorry for so many questions but I really appreciate the help!

[brywheat]

The gelcoat is also completely shot. . I've started exterior sanding and hit the glass in a few spots.. grinding down all cracks. Does the gelcoat all need to come off? 2hrs sanding didn't get a lot done.. I'll post some pics in the am

[bradford]

All the gel coat doesn't need to come off.

Going back with paint will be a whole lot easier.

[brywheat]

It's in the blood, Picture of my great grandfathers ship building tools. My dad donated them to our local maritime museum.


Pics of the gelcoat, where I have sanded and alot more to go






Next couple pics are for fairing related questions. How thick can fairing be on its own? At what thickness should i be adding CSM?




This last pic has me concerned. this is the top where the outter and inner skin match up. Looks like it's resin starved? recomendations on fixing?





Bored at work


Thanks again for your input & help!!

[tartuffe]

That photo you refer to as resin starved, don't think that is what is going on there. Not really sure what is going on there from the photo. I would't blow that up until you get some more pics to see what exactly it is we are looking at.

Just curious if that area seems weak? Can you separate the layers with little force. My boat has an interior liner so I'm not familiar with that style of construction.

[tartuffe]

Originally Posted by brywheat

Tartuffe

For composite board dose it have to be infused vacuum bagged? Or whatever the proper terminology is? Doing research and it looks like awesome stuff. Did you start your rebuild onthe exterior of the hull? How did you flip it? Still have your support? Sorry for so many questions but I really appreciate the help!

You can use composites the same way you would use traditional wood. I started with the inside first, rebuilt the stringers and transom and then flipped the hull over. I put an I-bolt through the transom drain hole with big washers on the inside and out, tied a rope to the u-bolt where your trailer winch attaches, raised it up like a hammock and rolled her over with a friends help. Boat is pretty light without the cap on it/fuel tank, or floor. You can slide some stout sawhorses underneath and lower it back down.

[tartuffe]

The pic of the straightedge against the gunnel showing the wave in the hull, that will come out with the construction of the cap. Take it easy with the sanding. Sanding sucks and damn its enticing to go with a grit to actually make some progress like an 80 or even 60. In reality you should probably use a chemical stripper and a 200 grit. The more of that gelcoat you save the better. Gelcoat is a waterproof coating that protects the fiberglass from water intrusion. Its kind of like an insurance policy.

Most of your fairing will be with high-build primers and a longboard. Takes many coats but the lighter the color of the finished product, the more forgiving it is. These boats are not incredibly fair to begin with. I wouldn't be too worried with that. Few sanded coats of high build primers with some longboarding and it is what it is. We can talk about that after you get the structural fixed.