many questions about repairing/replacing stringers

[carboncow]

Originally Posted by Liam

While you are in the bilge area,providing you transom is good you may want to cut a mousehole and fill with resin and 1/4 chopped strand around the garboard plug,then redrill for a new garboard plug,leave the outer layer of the transom glass in place and fill from the inside,this will increase the life of you transom.

Man you got the best info! I'm following your solid to the "mouse hold discussion".

A surveyor on site when we picked up the old boat give our transom a "solid" rating...but that is about all we found solid. Should we clean up where the transom meets the hull and re-tab that out too as well as the drain comment from you?