my project wellcraft 180 fisherman

[mannydvk11]

corection this is the info of the panel 12V,1260mW,Charge rate: 70mA,Height: 6.5 in,Width: 7.0 in. All Weather Proof - Protected against wind, rain, salt air, and solar radiation, UV

[mannydvk11]

well i took it out for a bit after reparing the motor addit new reed vlves new carbs parts gaskets new gas and feul lines filter wow lots of new stuff any way here is a pic of the boat in the water

[GREYWOLF]

looks like you are doing a great job, One thing what type of fuel lines did you use , some have big problems with the ETHANOL in the fuel they tend to rot and leak much sooner then the gray ones ?

[mannydvk11]

Originally Posted by GREYWOLF

looks like you are doing a great job, One thing what type of fuel lines did you use , some have big problems with the ETHANOL in the fuel they tend to rot and leak much sooner then the gray ones ?

well according to the guys at the marine store this one is good to use with ethanol i had the gray ones but i was having a problem it kink to much so i was having flow problem

[GREYWOLF]

I hear you I used to use the black automotive hose but several of my outboards had carb problems with crap from the fuel lines , I went to the new grey type ,did have some problems with kinking in hot weather, but no contamination in the carbs, the trick is to rout the hose with no sharp bends

[mannydvk11]

Originally Posted by GREYWOLF

I hear you I used to use the black automotive hose but several of my outboards had carb problems with crap from the fuel lines , I went to the new grey type ,did have some problems with kinking in hot weather, but no contamination in the carbs, the trick is to rout the hose with no sharp bends

yes you are right ill see how this ones will go and then ill get the gray ones my problem with the one i had it was short so i just replace them

[randlemanboater]

Very nice job on your boat...it looks great!