So Here She is

[tartuffe]

Originally Posted by cterrebonne

How did you measure to make sure that the stringers went back in the same place and height?

I ran strings through marked holes in the hull from the rub rail screws. I numbered the holes and wrote down the measurement from the edge of the hull to centerline of the stringer and the distance below the string to the top of stringer. I had other measurements but those were what I trusted the most. Most important thing was the outside to outside measurement of the hull to make sure the hull itself didn't "relax."

There is a picture in this thread of all the strings

[Well20F]

Originally Posted by tartuffe

I ran strings through marked holes in the hull from the rub rail screws. I numbered the holes and wrote down the measurement from the edge of the hull to centerline of the stringer and the distance below the string to the top of stringer. I had other measurements but those were what I trusted the most. Most important thing was the outside to outside measurement of the hull to make sure the hull itself didn't "relax."

There is a picture in this thread of all the strings

Now that youre done I will send my 1984 Center Console to you.