![]() |
|
|
|
#1
|
||||
|
||||
|
Not that yours is anything like mine but here is where mine was located.
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny |
|
#2
|
|||
|
|||
|
Thanks guys,
Mine is just like yours tsubkaki. But I wasn't sure if I should try to remove that part, it had a valve in front of it that I did remove, I ran a piece of weedeater line down it & only felt a bit of resistance, it went back & forth easy. I replaced the valve with a 3/8" barb fitting & replaced the first filter since I had a spare on board. Going to try & run it after lunch & see.
__________________
Doug 87 Cuddy with a 94 Black Max 200! & a 1983 Cuddy, looking for power. |
|
#3
|
|||
|
|||
|
By the way
When we were out there we pulled up on a wilderness beach all alone. few minutes later another guy pulls up a hundred yards up, 85 wellcraft with a sweet Yamaha!
__________________
Doug 87 Cuddy with a 94 Black Max 200! & a 1983 Cuddy, looking for power. |
![]() |
| Thread Tools | |
| Display Modes | |
|
|