|
|
|
|
#1
|
||||
|
||||
Good info, Thanks Phatdaddy. I forget T-stats.
That is a big one right there. It looks like the fuel rail comes off to do those on this one. Damn. It shall be done. Poppet, I have done two on Opti's now. I waited until the diaphram bit the dust and flooded the cowl with salty H2O on the first one.. Second one was done as a preventative measure. Anyone else, I certainly didn't mean to limit the field on this inquiry. I know there are some brilliant folks here beyond those mentioned. LOL Thanks in advance..
__________________
 1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS 
|
|
#2
07-03-2013, 12:29 PM
|
||||
|
||||
|
If you wanna go all out you could send the injectors(all 12) out to BROCATO for cleaning and flow testing. And not sure on the OPTI, but I know on most dry throttle bodies you should clean it out as well as the IAC every so often.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#3
07-03-2013, 03:14 PM
|
||||
|
||||
|
Motor is still running like a top. Injectors, air/fuel, that would be a winter job. This thing has IAC? I bet you are correct about the dry intake with reeds it will be gummy on the backside of the throttle plate. I will look into it. I have been hesitating to do anything except put fuel and oil to her. I hear the TPS is a joke and cannot/will not take even so much as a drop of water.
Scallop season is on us, vacation too, don't want to get too involved. Can't afford the down time. I was thinking of pulling the VST for a good cleaning and do a decarb. Still running ringfree, and 93 or 91 recreation.. Thanks again
__________________
1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS
|
|
#4
07-03-2013, 03:52 PM
|
||||
|
||||
|
lower unit oil, ck the trim oil, take prop off and grease the splines, sounds like you got the rest, i was going to also say t stats but phat beat me to it!!
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#5
07-03-2013, 04:04 PM
|
||||
|
||||
|
just do the basics, put a new water pump in it(mercury brand only), make sure the oil line to the compressor is clear. I'd look hard at the VST unless you knew wildman was already in there. Look at the thermostats and keep on running it.
|
|
#6
07-03-2013, 04:36 PM
|
||||
|
||||
|
Hey Ridge, give me a call
|
|
#7
07-03-2013, 04:45 PM
|
||||
|
||||
|
Thanks and thanks.
Just returned from the Mercman getting place. No t-stats on the shelf, recommended I take a peek. Tomorrow morning I will jam on it.
__________________
1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
