So Here She is

[chumbucket]

I have to concur. That is one of the finest V20's I have seen. You should be very proud. That thing is good for another 30 years.

[Kracker Jack]

hey bud I got your message on tht. I will take all the scrap parts ya got. pm me when you get a chance.

[macojoe]

yep like already said, one of if not the best V20 I have ever saw!!!!!!!!!!!!!!

[cterrebonne]

How did you measure to make sure that the stringers went back in the same place and height?

[Cam]

After making the boat look that good, I would never want it back in the water again!!!! lol. Fantastic job!!!!

[bgreene]

Boat looks fantastic - congratulations. Just really great.

[Destroyer]

Originally Posted by bgreene

Boat looks fantastic - congratulations. Just really great.

X2 totally argee

[tartuffe]

Originally Posted by Cam

After making the boat look that good, I would never want it back in the water again!!!! lol. Fantastic job!!!!

Thanks for all the kind words fellas! I had never been so nervous as that first trip back to the ramp. I've had her out about a dozen times now including twice about 50 miles offshore so its like old times. Even got a small scratch that didnt bother me. When not in the water I found a great covered storage area

[tartuffe]

Originally Posted by cterrebonne

How did you measure to make sure that the stringers went back in the same place and height?

I ran strings through marked holes in the hull from the rub rail screws. I numbered the holes and wrote down the measurement from the edge of the hull to centerline of the stringer and the distance below the string to the top of stringer. I had other measurements but those were what I trusted the most. Most important thing was the outside to outside measurement of the hull to make sure the hull itself didn't "relax."

There is a picture in this thread of all the strings

[Well20F]

Originally Posted by tartuffe

I ran strings through marked holes in the hull from the rub rail screws. I numbered the holes and wrote down the measurement from the edge of the hull to centerline of the stringer and the distance below the string to the top of stringer. I had other measurements but those were what I trusted the most. Most important thing was the outside to outside measurement of the hull to make sure the hull itself didn't "relax."

There is a picture in this thread of all the strings

Now that youre done I will send my 1984 Center Console to you.