Cuddy step up

[buckleyjr]

You are right. There was a guy that had a removable wooden step ladder. He posted some pics and it looked really nice. He even explained how he made it. It clipped into the top and was at a slight angle. Made of teak, I think.

[Hedge]

I think this is the thread you are talking about, it's amazing what you can find with a search

http://www.wellcraftv20.com/communit...ht=step+ladder

[jeffmo]

That's my boat and the ladder works very well. My old knees aren't what they use to be and it makes getting onto the bow alot easier.

[SkunkBoat]

buy a $3000 hard top. then you can swing into the cockpit from the bow!
well, doesn't help much getting up there though.

I just put in new starboard deck lids and it really got a lot easier than stepping on a pile of life jackets, a fender, and cutting board...covered with a landing net

[garbubba]

I saw that thread, that's what gave me the idea that I'm working on now. He had leftover boat steps & guess what? I do too.


Hedge, two things,

no steel on bubba's boat, I hate rust.

The other thing, I'm big, about 275, but I've been bigger than that & I jump all over that cuddy roof throwing a cast net, it gives a bit but it's tough.

I'm still in a hardware bind but I live in the right place & I'll work it out.

I'm adding pics of what I'm working with, & what the previous owner had.

Doug

[garbubba]

Here's what I built a few years back, two covers, cypress & stainless, can fit three buckets (4gallon) under there!

[garbubba]

This project on hold as I service bearings & replace fenders. Half the trailer is up on jackstands & I don't want to bounce it around.

New (diamondplate!) fenders should be here Tues. I have the step in the shop & I'll have it ready for hardware when I can get back to that part.

Doug

[garbubba]

OK 1 new set of bearings, 1 new tire & rim, new diamondplate fenders, new LED lights with stainless hardware,new wiring harness & side lights too, just to top it off.

All Done!

I'll get back to the step in the morning, ordered hardware, should be here Monday, so it's just final fit & sanding & I need to make part of the hardware.

Doug