my project wellcraft 180 fisherman

[mannydvk11]

now i have some questions to you guys regarding the gas tank should i replace it fix it like patching up the hole or should i cover the old gas tank are and add a small gas tank

the motor lots of ppl say they are bad are they really should i even try to fix it

thanks guys for the opinions and any Questions

[spareparts]

spend the money and put a new tank in place, yo won't regret it

[GREYWOLF]

looks good, I agrere buy a new tank , when you remove the old tank you will get a good look at the stringers and plumbing systems . nice find

[mannydvk11]

How about the motor should I rebuilt o just get a difrent one have any one change the bracket to be able to stear and tilt with a difrent bracket using the omc

This is the bracket I order



This is how I wanted to look

[mannydvk11]

guys i have a new question i am debating if i cut the transom to put the engine what will be the right way to do that also i am thinking on not reusing my gas tank will be a good idea to cover the hole not put the tank and use one of those portable ones reason why is my tank have a small hole in


my main concern about the platform is my friends boat have one similar to the one i like and every time he open up the bow go up hi he had to get bigger tabs to be able to control that i am not looking to spend to much extra money and if i get the platform it sure looks good but my ride will be a pain

if i do this will i have to cut the top of my transom or i can use it like this

[phatdaddy]

not sure i am understanding, are you considering cutting the top off of the transom and then cutting a notch to accept a conventional outboard mount. when you remove the seadrive mount there should be a small hole in the center that your cables ran through and then 6 or 8 holes that the bracket was mounted with. you should have a pretty clean palate to start your rebuild. check the transom for rot, if ok just fill & patch the holds.
i think you would be money & looks ahead to dump the seadrive, mount either bracket you pictured, and get another motor.

[mannydvk11]

Well my problem is I don't want to cut the top every one is telling me I won't be able to mount the motor and trim up plus it will obstructing the steering my idea is to get a bracket to move the motor back so I can steer and be able to move up the trim I like the platform but if I do get it also will need to get trim taps that is adding to the project