merc 3.7 head gasket

[spareparts]

You should be fine with the Victor head gasket, 9.4 will be OK especially with the aluminum head, run around 5 degrees initial with 87 octane(R+M/2), top out around 28 degrees to begin with, you can go higher, just try it slow to begin with

[aussie]

Originally Posted by spareparts

You should be fine with the Victor head gasket, 9.4 will be OK especially with the aluminum head, run around 5 degrees initial with 87 octane(R+M/2), top out around 28 degrees to begin with, you can go higher, just try it slow to begin with

ok thanks just wanted to no what your advice was be using studs as well