|
|
|
|
#1
|
||||
|
||||
Joker,
I used a cheap puller I got from Harbor Freight to remove the flywheel on a 200 Evinrude (96). You will need to use fine thread bolts to attach the flywheel. Once you apply the needed pressure a good bump from a hammer and it should break free. I had to use a bench grinder to grind down a socket to get it to fit inside the flywheel to remove the center nut on the crank.
__________________
Regards Barry 1987 V20 (sold) :( 1996 23' Wellcraft 1991 V20 ;) 
|
|
#2
12-27-2012, 07:46 PM
|
||||
|
||||
|
take a light and a mirror, look up under the flywheel, I bet you got a magnet loose
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
