Replacing trim around rod boxes

[peiserma]

Well, opinions are cheap! Here's mine:

It assume you already have the tools to rip and route the PVC material, and its cost does not seem high. Compared to the cost of teak, and the amount of work required to maintain teak, it seems like a fairly inexpensive experiment even if it lasts only a season or two. Try it and see how long it lasts.

Be aware that routing plastics will require sanding. The speed of the router bit will generate a lot of heat, and cause the plastic to melt. I have cut (using a circular saw) and routed plexiglass, that's how I know. That is why sanding will be required.

Even if you have to buy the tools, it would be worthwhile experimenting with the PVC first, That's because, were you to so it in teak, you'd have to buy the tools anyway. And teak is not cheap!

[macojoe]

In my boat I removed all the teak! I fish and have no time for maintenance! A bottle of bleach a brush and hose is all i wanted to do!
Starboard is the way to go if you can find a outlet in your area. West Marine will be highway robbery!
We have a place here that I bought sheets of it for my boat!

[spareparts]

buy one plank of epe' decking, rip to size, replace all the teak trim with it

[jasoncooperpcola]

I am doing the same on my rebuild. Absolutely no teak! I hate the stuff after all the time and effort and money I put into completely replacing all the teak on a 250 Sportsman just to have it look like crap three weeks later. NEVER AGAIN! We have a place here in Pensacola called Creative Acrylics that is supposed to have good prices on starboard. Either that or use fiberglass covered wood then painted.

[awthacker]

Originally Posted by spareparts

buy one plank of epe' decking, rip to size, replace all the teak trim with it

Can't find epe decking on google. I imagine its just some sort of pvc deck material. I would be looking for something nearly 1.5" thick, that way I could rip 3/8" strips that were 1.5" wide.