Cap is off

[tartuffe]

Something that can be completely glassed in one session and then bolted or screwed to the boat is a good candidate for vinylester; pilot house, tackle station

You can start a project with epoxy and come back within 24 hours without having to sand and you will still get a chemical bond. Vinylester requires sanding to get a good bond. Basically if sanding is easy than vinylester but if its an area where strength is critical (bracket) epoxy. Not that vinylester won't work but epoxy is much more forgiving of applicator error.

Real good example is if I was replacing my transom from the inside again I would try vinylester on my next go around but if I had to replace it from the outside as in cut the skin off then I would use epoxy.

[jasoncooperpcola]

Got to do a little sanding on the bottom paint today. It is much easier on a flipped hull. Got about half of the port(?) side done. The entire keel is still covered with bottom paint. And it is the worst. My plan to tackle the keel is 40 grit paper and a big fan. This paint is 3/16" thick in spots. I have been chiseling off the thickest and sanding. I just wonder how much weight I am removing. Not to mention all the gel coat damage I have uncovered.

[jasoncooperpcola]

So far the wood chisel is the best tool for removing this paint. Takes quite a bit of elbow grease but its coming off! Working the keel now. Got the bulk off both sides and just have around the strakes left.