Bow slider - water intrusion eliminated ?

[Blue_Runner]

B - if all else fails send the pics to me and I will post em for you.

p.s. I might need to get one of these bow slider cover things from your canvas man for my boat!

[Destroyer]

Originally Posted by Blue_Runner

B - if all else fails send the pics to me and I will post em for you.

p.s. I might need to get one of these bow slider cover things from your canvas man for my boat!

Ditto

[bgreene]

No problem guys. Got the call to come check it out so I'll be there at some point tomorrow.

V21 owners know exactly what this is all about - dry cuddy - never mind the weather conditions.

[bgreene]

Bow slider cover results so far

1. ......washed the boat as usual including the bow and hosed off including the windshield - then found the cuddy to be dry, not damp, dry.

2.......light rain overnight - then found the cuddy to be dry, not damp, dry. Had the full boat cover off just to see what happened.

So far good results with the bow cover. The outer edge rubber flange makes solid contact with the bow deck, so that accounts for most of the needed coverage - front and both sides. The rear section fits under the center windshield, so that area is essentially water proof. The only allowance for water intrusion can be at two very small outer edges of the cover as it curves out from the windshield, and that would/ should steer water into the track that goes down to the deck floor. Think I've got this accomplished. More to report when I encounter prolonged heavy spray and such.

[Destroyer]

Originally Posted by bgreene

Bow slider cover results so far

1. ......washed the boat as usual including the bow and hosed off including the windshield - then found the cuddy to be dry, not damp, dry.

2.......light rain overnight - then found the cuddy to be dry, not damp, dry. Had the full boat cover off just to see what happened.

So far good results with the bow cover. The outer edge rubber flange makes solid contact with the bow deck, so that accounts for most of the needed coverage - front and both sides. The rear section fits under the center windshield, so that area is essentially water proof. The only allowance for water intrusion can be at two very small outer edges of the cover as it curves out from the windshield, and that would/ should steer water into the track that goes down to the deck floor. Think I've got this accomplished. More to report when I encounter prolonged heavy spray and such.

Sounds good Greenie...but.......

[macojoe]

You been sleeping!! The pic's are here, scroll down

http://www.wellcraftv20.com/communit...ad.php?t=18203

[Blue_Runner]

B - but the real question is, does the slider cover keep fish blood out of the cabin?

p.s. Blue is jealous of your recent striper fishing success, btw.....congrats on that!

[Destroyer]

Originally Posted by macojoe

You been sleeping!! The pic's are here, scroll down

http://www.wellcraftv20.com/communit...ad.php?t=18203

Naaa...saw them already MJ... I was talking more in the range of some close up pics of the cover and of the attachment system, the gasket(s). How it's made, etc. The engineering part of it.