Stripping bottom paint

[jasoncooperpcola]

I am done with the paint stripper. My pressure washer is being a pos. Runs for five minutes then I have to drain the carb, for it to run five more minutes. The gelcoat on the V20 is being destroyed because I cant get the paint stripper off fast enough. So far its been only on the strake edges, which are the worst. The gelcoat is just flaking off in pieces.

I need to get my garage cleaned out so I can get the hull in there. I should be able to pull the cap this next weekend. I figure once I get the hull in the garage on blocks I can sand the remaining paint off rolling around on my creeper.