|
|
|
|
#1
|
||||
|
||||
Measured and the tabs are 8x12. One of them is a little slower than the other, air in the lines? I wont be mounting them until after the bracket and painting. I was thinking about drilling oversize holes and then filling them with thickened epoxy. Then redrill the epoxy for the screw? Or should I just drill the hole fill it with epoxy then drive the screw into wet epoxy? Either way I will be going into a fresh transom and I want all my work to last as long as possible.
Also what is the distance from the top of the hinge to the bottom of the hull?
__________________
1983 V-20 capsized. . . . in the garage. 
|
|
#2
09-08-2012, 07:20 AM
|
||||
|
||||
|
If they were parting the boat out I would have taken the wires!
Go to the Bennett web site they have install instructions there. http://www.bennetttrimtabs.com/pdf/i...structions.pdf wires http://www.bennetttrimtabs.com/pdf/i...structions.pdf
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#3
09-08-2012, 08:49 AM
|
||||
|
||||
|
MJ they were wrapped up with the big Merc harness. No cutting on that. Although i did need that harness too
__________________
1983 V-20 capsized. . . . in the garage.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
