|
|
#11
|
||||
|
||||
They are four years old. The complete setup is there, switches to tabs. Might have to get new hoses due to his V being a center console. $200 may be a little high but the set retails over $500. I still need to find out the size of them. Already a tight area on the transom with the megabracket.
__________________
1983 V-20 capsized. . . . in the garage. 
|
|
#12
09-06-2012, 03:17 PM
|
||||
|
||||
|
Quote:
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#13
09-06-2012, 03:28 PM
|
||||
|
||||
|
I am pulling them tomorrow after lunch. What tools do I need? Battery drill, phillips tips, and my set of gearwrenches is what I was thinking.
__________________
1983 V-20 capsized. . . . in the garage.
|
|
#14
09-06-2012, 04:27 PM
|
||||
|
||||
|
Mine are 5 years old now and always in the salt, not one issue!! They are Bennets and work great on the Ox. Adjustment on that boat takes a count of 1 and makes a differences!
Install was not that hard, except getting them bled, make sure after install yo ck often to be sure the oil is full! After a few times they will be fine and no worries. I have never added a drop to mine in 5 years! When putting lines together I used Teflon tape on all connections! Tools to remove will be Philips head screws, wrenches, a few rags to clean up fluid, maybe a pry bar if they are like mine with a ton of 5200. Maybe vice grips in case one or more screws get stuck in there and you strip the head?
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!!
|
|
#15
09-06-2012, 04:28 PM
|
||||
|
||||
|
Here is a pic.
 He also has a Furuno 600L bottom machine for sale, are they any good?
__________________
1983 V-20 capsized. . . . in the garage.
|
|
#16
09-06-2012, 04:37 PM
|
||||
|
||||
|
I had a Furuno 620 and loved it! But sold it when I bought my Garmin 4210 all in one, Radar, Chart plotter, and sounder, I bought a wire to convert my thur hull ducer to Garmin so I did not have to go thur that again!!
__________________
1986 V20 Old Fishermen never die, we just SMELL that way!!
|
|
#17
09-06-2012, 04:47 PM
|
||||
|
||||
|
He is asking $150 for the Furuno.
__________________
1983 V-20 capsized. . . . in the garage.
|
|
#19
09-06-2012, 05:01 PM
|
||||
|
||||
|
The tabs pictured are BENNETS, not lencos.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#20
09-06-2012, 05:02 PM
|
||||
|
||||
|
Quote:
__________________
1983 V-20 capsized. . . . in the garage.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
