Painting the Floor...

[Destroyer]

Originally Posted by Kracker Jack

Destroyer, the bedliner you used did you roll it or spray? Did you buy the clear base and then tint it your color? Can you get it in white? Do you need to prime the surface? Thanks Des!

I sprayed it on since I did the work in my brothers garage. (No wind to contend with and also it's the recommended way to apply the product) The base comes pre-measured in a bottle, (4 bottles to a kit) you add the hardener into it, screw on the cap and shake for 2 minutes to mix, then remove the cap and screw on the shutz gun to spray it. As I recall, yes it comes in a white version also. No, you only need to prime the surface if it's bare metal. For fibreglass just lightly scuff the area with a sanding disk, clean and degrease and you're good to go.