1708 mat for stringers

[tartuffe]

Big zip lock bags with some duct tape on one edge then cut the corner off to make it like a pastry bag to squeeze out like icing. Smoothed the radius with plastic spoons.

[cterrebonne]

Originally Posted by tartuffe

Big zip lock bags with some duct tape on one edge then cut the corner off to make it like a pastry bag to squeeze out like icing. Smoothed the radius with plastic spoons.

makes sense. thanks. This is off topic for this thread but how many sheets of ply did you use for your transom?

[tartuffe]

2 sheets of 3/4" marine grade ply, birch. You just can't get two transom cut-outs out of 1 sheet. Very close but not quite possible.

[cterrebonne]

Originally Posted by tartuffe

2 sheets of 3/4" marine grade ply, birch. You just can't get two transom cut-outs out of 1 sheet. Very close but not quite possible.

So your ply in your transom is 1.5"? I was way overkill thinking 4 sheets. for 3 inches of ply.

[tartuffe]

2 sheets is fine, that is what the factory originally installed.

[cterrebonne]

Originally Posted by tartuffe

2 sheets is fine, that is what the factory originally installed.

Sweet. You think I should use 3 since I'm going with a bracket? Or the knees would be fine?

[tartuffe]

I don't have any experience with brackets and don't know how they distribute force on the transom.