How to eliminate water getting through the bow slider ?

[bgreene]

Originally Posted by Blue_Runner

I bet it is those trim tabs. Just send them to me and I will dispose of them properly

I thinking of what I'll call a " drag gasket" ............ a rubber strip about 4" wide attached to the outside bow slider that wick's away water from getting in. Abviously not completely water tight, but if dragging flush along the bow deck, could essentially shield all rain and spray.

White color, so as to blend in nicely and possibly attached with an adhesive to avoid drilling holes. Not sure yet - just a thought. Might be able to make it look like " factory equipment" if done right.

ps - the trim tabs work great on this hull..........again this past Saturday, 1-2' rolling chop and just a touch of tab bow down was all needed to eliminate the pounding that engine trim could not alone. Good stuff.