|
|
|
|
#1
|
||||
|
||||
Barbourplastics.com has more reasonable prices on rubrail. Taco is an excellent product but a little pricer
|
|
#2
04-20-2012, 06:09 AM
|
|||
|
|||
|
Thanks for the info. I found a kit (50') from Taco for $200 plus a $50 rebate. I didn’t think that was too bad. I think I’m going to epoxy the holes, seems like the hull has some movement and that caused the hole to elongate. Is there a better way to tie the hull to the liner (besides just screws) so this doesn’t happen again?
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
