Va Beach v20 project

[Kracker Jack]

You can see in these pics how I made the gunwale supports rock solid. Not only did I glue and screw them but I also glassed a strip on them inside and outside and kinda "tied" them together before I glassed them on the boat.

[Kracker Jack]

heres how the bottom side of the rail has shaped up. I glassed one layer of 1708 to the band tying it into the hull I then at the point of contact to hull made a "fillet" or radius with thickened resin and chopped glass mixture. Just remember another layer of 1708 will rap that rail when I glass my cap to the hull. No chance of water intrusion under that rail!!!

[Kracker Jack]

Im off tomorrow so I will be roughing in the cap!! thank god!!! shes getting there fellas slowly but surely.

[Kracker Jack]

I didnt get to the cap today. I concentrated on finishing up glassing the inner rail to the hull and encasulating some of the gunwale supports. As seen in the pics the bottom of the rail was filleted and the the cloth glassed down the liner about 1" 1/2.

[Kracker Jack]

pic of the 4" stainless screws used to screw thru the rail and into the gunwale supports. the recessed screws were then filled with thickened resin.

[Kracker Jack]

heres an over all picture of how the boats coming along on the interior. I would like to be glassing the cap on by this weekend but overtime is propably gonna start so I can only work on the boat after work for awhile

[Kracker Jack]

grinded some rough spot after work today getting her scuffed up for fairing.

[Kracker Jack]

Here's some pics of the boat getting the floor plan fine tuned so I can take some measurements and references to cut holes in my floor for my utility/acess hatches. And also a couple pictures of my 2 beautiful ladies!!!!!

[tartuffe]

Coming right along, I'm looking forward to your paint job. Quit around with lights and get to sprayin!

I kid, my neighbors must think I have a screw loose for the amount of time I just stare at my boat thinking of the goodies I want to put on her.