|
|
|
|
#1
|
||||
|
||||
That looks great.
 I never heard of Arjay, so i googled it. Did you use the Pourable ceramic compound? You went with a 25" transom, so is another motor in the works?
__________________
1983 V-20 capsized. . . . in the garage. 
|
|
#3
04-17-2012, 11:11 AM
|
||||
|
||||
|
Yea, he is a good little helper..
I used the ceramic pourable, I was very impressed, easy to work with and very strong. I looked at Sea Cast that happens to be made near by, its almost double the cost, This seemed like a very good alternative. Very happy with the results.
|
|
#4
04-17-2012, 07:30 PM
|
||||
|
||||
|
Quote:
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#5
04-18-2012, 09:59 AM
|
||||
|
||||
|
Nice job...I can see that in my future...need to do the floor first I think though.
__________________
1986 V-20 1986 Yamaha 150 HP
|
|
#6
04-18-2012, 07:27 PM
|
||||
|
||||
|
Looks great! And from the timestamps on the pics, looks like the whole project took less than 3 minutes
|
|
#7
04-29-2012, 06:17 PM
|
||||
|
||||
|
took the v20 out, finally!!
Dad and I took the boat this week end for a shake down cruise. Man, is that etec nice. Boat performed very well, almost 5mpg at 30mph and thats running double oil since it has no hours on it. so far top speed is 48mph. You can see from the picture the little bilge is very tight, with two batteries, two bilge pumps, oil tank, live well pump and thru hull tranducer. So far i'm very happy with the entire set up. I guess all the hard work has paid off.
|
|
#8
05-09-2012, 06:42 AM
|
|||
|
|||
|
transom rebuild
Nice job, Did you use ceramic and pour it, or wood? If ceramic how much did you use? Thank You
|
|
#10
05-09-2012, 06:29 PM
|
||||
|
||||
Looks Great!!! You're gonna love that ETEC. What size prop are you spinning?
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
