Spare in the Hospital

[tsubaki]

The best reliable info I've ever found is to try it and see.
I've been told the same that you've already found out. Some shoot most anything without any problems.
Seems to be firearms of the same make or even consecutive serial numbers have some subtle preferences.
Other things also can come into play. When I let my brother in law shoot mine I witnessed limp wristing being a problem feeding. Yet it did fine with me.
Also have an XD I have yet to try out. Been told they will eat anything, also been told they don't tolerate SWC's.

[tsubaki]

I'm sure you've read about using "the best brass" etc,etc.
As you see, I don't discriminate.

[tsubaki]

Oh, about molding your own. I'm sure you've seen about the need to lube the bullets. This was the only thing that has slowed me from doing my own.
Even though I'm doing .451RB for a 44 cap & ball, 320gr REAL for 50cal and 1oz Drive Key for a slug gun, I just can't make myself do stuff for metallic cartridges.

[willy]

If you are intending to use the Glock with lead bullets please order a replacement barrel from Barsto or similar as the type of rifling they use is not appropriate for lead bullets.
great guns, I have two, a 21 and a 30. But I would not use my reloads in them. Also the chambers in Glock factory barrels are not a full support (for the case) type barrel. That is a problem with reloads, especially for multiply fired brass.
Again great guns, just use them within respect of Gastons intention and design.

[tsubaki]

I've finally took the time to actually research the Glops instead of letting opinions prejudge me.
I'm actually very impressed with them and would definitely consider a Model 20 although just a few more mm's of barrel length would make me happier.
I completely agree with willy however as with most things I'll bastardize stuff in a flash.
This is what I've determined.
The factory barrels "will" shoot lead stuff fine and without hazard "if" you are diligent to remove the lead deposits. Seems the rifling design accumulates lead more readily than others normal barrels. A replacement barrel for the constant use of lead stuff would be a better idea.
The reloaded ammo "will" be fine "if" you follow correct reloading basics of brass inspection and preparation. The unsupported chamber will show defects of the brass in a most negative way through rupture.
The combined two designs can easily cause major problems due to improper maintenance and defective reloading procedures.
I'm still impressed with the Glocks but have no real physical basis for this.

[spareparts]

first morning without the prescription meds, just ibuprofin, one word for you oooooooooooooooooooooooooooooooowwwwwwwwwwwwwwwwww !
I'm sore and moving real slow, looks like another day in the recliner.


As far as the glocks go, I was surprised how much disinformation was claimed to be fact, the internet pissin matches were over the top,you'd a thought some one said something bad about a Wellcraft. General consinsous is if you shoot lead, keep pressue low, use hard alloy, clean often. The lead haters seem to be the same ones who wash their glocks in the dishwasher and swear they only need to have it done every 5000 rounds. I think I'm going to play it safe and buy bullets for now, might buy a barrel, awful tempting to get one with threads on the end and apply for the stamp.On another note, I've been shopping a 9mm for the wife, got it narrowed down to Ruger SR9, G19, or trade in Smith 6906, I'm liking the Smith more and more, I can get one for under $400. Any opinions on the Smith?

[tsubaki]

Too soon for bourbon intake?

I have no experience with those three but recall no bad opinions of them either.
Let her pick from the ones you're comfortable with. I'm sure you don't dare pick what shoes she has.