|
|
|
|
#1
|
||||
|
||||
these are lighted switches, one plug is for power, 1 for ground, one is fro the light on switch, it should come with directions when you buy
__________________
1986 V20  Old Fishermen never die, we just SMELL that way!! 
|
|
#2
03-19-2012, 01:41 PM
|
||||
|
||||
|
You will need a 60 amp fuse between the fuse panel and the battery. The switches are actually 15A breakers on the ones you gave link to from West Marine. (reset by turning off and then on again) They want to ensure that your positive lead wire from the battery to the panel is properly fused. The single screw design just makes it so you hook one ea positive and negative and then go to your load with the 1/4" spade connectors from there. Personally, I would stay away from it with the soldering iron. The soldered points on the negative board are for the led lights inside the breakers. On the positive board they appear to be the feed for the breaker switches and the led lights. Buy a terminal block for the negative wires. Label them in some way so if you have a problem it is easily diagnosed.
__________________
 1996 -19' NV Flats 115 Mercury 4-stroke 1983 -20' Wellcraft Center Console 250 XS
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
