|
|
|
|
#1
|
||||
|
||||
First off let me be the first to say WELCOME
I'm thinking the transom IS supposed to be curved... If nobody confirms I can check mine to be sure but I 'spect one of the experts will be along soon enough. 
|
|
#2
02-19-2012, 02:23 AM
|
||||
|
||||
|
Yes, there IS a bow to the transom on these boats...they are not flat...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#3
02-19-2012, 04:17 AM
|
||||
|
||||
|
Definitely bowed transom.
Isn't that an oxymoron?
__________________
Heavily medicated for your protection.
|
|
#4
02-19-2012, 08:30 AM
|
||||
|
||||
|
did you say Oz is a moron?
|
|
#5
02-19-2012, 08:39 AM
|
||||
|
||||
 
__________________
Heavily medicated for your protection.
|
|
#6
02-19-2012, 08:48 AM
|
||||
|
||||
|
There only flat in the very middle where teh engine bolts up, curved between there and the hull sides.
__________________
2011 SUNDANCE B20CCR SKIFF, 2011 YAMAHA 90HP 4 STROKE, 2011 KARAVAN SINGLE AXLE ALUMINUM TRAILER, LOWRANCE ELITE-7 HDI, MINN KOTA RIPTIDE TROLLING MOTOR 2000CC HYDRA-SPORT 225+HP EVINRUDE SOLD  AND THE PINK JEEP!!!! R.I.P. http://www.wellcraftv20.com/communit...ad.php?t=11664 
|
|
#7
02-19-2012, 11:18 AM
|
||||
|
||||
|
Hey thanks for the welcome.
Regarding the transom being bowed, I was afraid that was going to be the answer. I could not figure out why those boards would be cut at an angle. This just added a good amount of brainpower (and I'm already at max power) in figuring how to proceed with doing this properly given my set ot tools and carpentry skills.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
