|
|
|
|
#1
|
||||
|
||||
In that case, I'd just throw it on and try her out.... having the engine 5" low will limit how much you can trim up for speed without porpoising but unless you need to run very shallow water it won't hurt a thing.
|
|
#2
02-16-2012, 11:58 PM
|
||||
|
||||
|
After a little thought i decided to go ahead and get the fixed jack plate. Got my square tubing cut to size and found out the tubing would have to be at an angle and then the transom side holes would not hit the tubing, if i had 4" tubing it would work. But i had 3". A little bit of a leap before i looked issue.
 Maybe i can use it for a bow guide now for the trailer. 
__________________
1983 V-20 capsized. . . . in the garage.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
