starting rebuild on '94 Evinrude 175hp

[smokeonthewater]

You can likely reassemble it by yourself but you will need a service manual and you need to do a bit of reading on basic engine knowledge mainly because you need to know the correct terminology to read the manual.... The parts may not NEED surfaced but they need to at least be checked by someone who absolutely knows what they are looking at.... It would not be a terrible idea to have a pro put the engine back together but that doesn't mean you CAN'T do it.... Since I've never met you I really have no idea of your mechanical aptitude.

What some folks can do half asleep with a hangover can give others fits on their best day and it is not just a matter of education or lack thereof....

[THEFERMANATOR]

You do NOT turn the crank in a 2 stroke engine, and you do NOT use regular wet dry sand paper on them either(only use 1000 grit or higher crocus cloth). The crank and rod surfaces are machined to a mirror finish and then hardened. In a 2 stroke the bearings do not ride on a cushion of oil, so the surfaces MUST be a much harder finish, and must have a mirror finish as well. The actual bearings are made of a soft material, but the crank and rods are have a HARD surface on them. In a 2 stroke when the surface is under factory spec, you either have th crank rebuilt(welded, turned back down to stock, and heat treated. VERY EXPENSIVE to have done right), or you replace it with either a good used one or new one. Also rememebr that since in a 2 stroke there is no cushion of oil present, the bearing tolerances must be MUCH more precise.