Va Beach v20 project

[reelapeelin]

Originally Posted by Kracker Jack

Im also going to have 2 ball scuppers at deck level on port and starboard.The floor has factory grade to the rear seeing how the stringers i installed are factory height.

I had a '74 for 11 years...and your plan worries me a bit...the 70s models had floors set AT water level....later when Wellcraft went to a self draining floor deck, it was RAISED above water level to accomplish that function...if you install scuppers AT water level, even the ball type, will you have the draining capability you're looking for?

[Kracker Jack]

My plan was to not install the scuppers till i splash it and find out floor height ( BUT IT WAS IN THE DRAIN PLANS) LOL!!. My dad had scuppers on his, but his was a 84'

[reelapeelin]

Originally Posted by Kracker Jack

My plan was to not install the scuppers till i splash it and find out floor height ( BUT IT WAS IN THE DRAIN PLANS) LOL!!. My dad had scuppers on his, but his was a 84'

That's why I brought it up as a concern...your dad's '84 was AFTER Wellcraft raised the floor and heightened the cap to make self-draining and put the fuel tank under the floor...good luck w/it and w/your skills, I'm confident if you install scuppers in wrong place, you can always reposition them...

[Kracker Jack]

Well today due to the holiday I was able to rough in my sole and also cut the hole for my splash "sump well". I recessed the rough opening on the sump liner hole so I can glue in my fabricated splash well and glass over the lip flush with the my glass for my sole.

[bradford]

She's gonna be sweet!

[Curapa]

Looking good brother!

[mike77v20]

looking good keep up the good work and if i may ask what are scuppers i am still grinding getting closer to being done though