|
|
|
|
#1
|
|||
|
|||
Welcome to the site and congrats on the boat!
__________________
*************************************** Stay Safe!  Sold - 1984 V-20 Cuddy with a 2003 Johnson 140 hp gas sippin 4-stroke. 1995 Ranger 250C with a 2015 Suzuki 300 hp 4-stroke. 
|
|
#2
01-06-2012, 02:50 PM
|
||||
|
||||
|
Nice look'n fish in that picture, but what is that "fish" on the wall?
 rkc
__________________
Sorry to say that I no longer have a 1984 V20 :(
|
|
#3
01-06-2012, 03:10 PM
|
||||
|
||||
|
Picture
Taxidermist's place, small male, about 15#'s. He had about 10 of them all over his garage, not sure if they were his or folks that only thought it was a good idea to stuff a fish and then changed their minds.
__________________
'83 V-20 Outboard '01 Mercury Optimax 150
|
|
#4
01-06-2012, 04:05 PM
|
||||
|
||||
|
Welcome to the site....great set of first posts. Looking forward to more pics....and dont forget about trying to find make and model of that cover.
__________________
1986 V-20 1986 Yamaha 150 HP
|
|
#5
01-08-2012, 06:51 AM
|
|||
|
|||
|
Welcome to the site...Alot of good information here.
__________________
 1974 V-20 Steplift CC 165 Mercruiser I/O "The fishing was good; it was the catching that was bad."
|
|
#6
01-12-2012, 10:26 AM
|
||||
|
||||
|
Bimini top enclosure beginning and model number for cover
Thought I'd post the in-process of my bimini enclosure, only have the front part started, but you kind of get the idea. This is about 4 hours worth of work to get it to this point. Figure I've got another 12-16 hours to finish, now I know why these things cost so much. Need to get it back on the boat once the weather is a little more cooperative and get the sides cut, fit, measured. Also plan on a rear curtain with a zippered door that drops straight down in the back so the cockpit area will be fully enclosable.
Also, there's pics of the storage cover. The tag info gives it's model number as 20152-152 and is made of 600D Polyester. There's no vendor info on it that I can find, but I'll keep looking. It was definitely aftermarket though, but it fits good for now until I start carving on the bow rails to mount my trolling motor. I'll have to modify the front a bit then.
__________________
'83 V-20 Outboard '01 Mercury Optimax 150
|
|
#7
01-12-2012, 10:36 AM
|
||||
|
||||
|
Cover Poles and vents
Forgot to add, I added the poles and vents, had to cut holes in the covers and install but it was pretty easy. Pics of the vents are below, they worked great.
__________________
'83 V-20 Outboard '01 Mercury Optimax 150
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
