V 21 for sell - Page 2

bradford · #1 11-02-2011, 04:50 PM

Quote:

Originally Posted by THEFERMANATOR

BIG AND MEATY! With the curves to match it all of course. Then again I have been refferred to as Sir Mix A Lot due to my like for BIG features on the womens

.

For Ferm...my brother.......

How's my old 225 Evinrude doing?

THEFERMANATOR · #2 11-02-2011, 05:32 PM

Hoping to finish tearing it down here shortly. I got the head and intake off of it and pulled the piston out of it and found that it stuck a ring from carbon build-up in the ring lands of the pistons. Unfortunately it put 1 groove in the cylinder wall that is a bit to deep for my liking, so I'm going to bore the 1 hole out and decarbon the other 5 and put it back together. Fortunately that cylinder that got messed up was still standard whereas most of the others are .030 over from when it was built before.

And that there be a FINE specimen of how they SHOULD be shaped. I like some meat with my taters

.

dmoore · #3 11-15-2011, 11:17 PM

Quote:

Originally Posted by bgreene

Took 7 months to sell my Mako but buyer emerged, knew the value and we were both pleased.

These V's have certain merit's to them, have a good following, and of course haven't been produced now for 15 years. Those that remain in excellent condition should retain value.

You damn right!