1984 Johnson 35 hp question for the OMC Guru's

[THEFERMANATOR]

Basically the pump can push more pressure than the seal in the water pump housing can take, and also the water discharge from the exhaust goes down through the midsection so some of that will blow out the seam as well.

[reelapeelin]

Originally Posted by THEFERMANATOR

Basically the pump can push more pressure than the seal in the water pump housing can take, and also the water discharge from the exhaust goes down through the midsection so some of that will blow out the seam as well.

I always believe a "leak" can flow both ways...when a motor that does what we're talking about is sitting at rest w/no pressure from the pump, does anything seep back into the motor?...if so, does that cause any problems?...

[THEFERMANATOR]

Originally Posted by reelapeelin

I always believe a "leak" can flow both ways...when a motor that does what we're talking about is sitting at rest w/no pressure from the pump, does anything seep back into the motor?...if so, does that cause any problems?...

No, because the powerhead sits above the water so the pressure isn't strong enough to push against gravity.