Emergency stop switch

[Cam]

Yep....motor will still crank but won't start. Check to be sure where the power ends and see if switch is no good.

[Joker2]

went down today using my Seloc manual disconnected the Black Yellow single pin plug at the power pack, engine started right up and ran fine, I couldn't stop it unless I plugged it back in. Unless I am reading the book wrong ( which very well could be ) this means either my Emergency kill switch or my ignition switch is bad correct? Can anyone verify this for me?

[tsubaki]

Three quarters of the time the problem is not the kill switch itself but the devise on the lanyard (whatever that is called) that is removable in a man overboard situation.
With age it tends to warp just enough to cause the switch to activate.

And yes I think you are on the right track, ignition switch or kill switch problem.

[Joker2]

maybe I'll just change them both, considering I don't really know how old the control box is, it's cheap enough.

[tsubaki]

You should be in a position to test them and see.
With the wire unplugged from the power pack test (with an ohm meter) to ground and see if you have good resistance (with the key in the on/run position), pull out on the kill switch to see if the resistance changes from zero to infinity. If so, it's the removable part of the kill switch that's the culprit. If not, it should be the ignition switch or something causing the closed circuit like a pinched wire.

In case I'm not making it plain. Zero resistance is a closed circuit position, open would read real high to infinity.
With the key switch off, you should get a closed circuit or zero.
With the key in the on/run position (if the kill switch is operating properly) you should get an open or infinity reading. If not pull out on the kill switch to see if it's the removable devise causing the problem.

Now if you still get a closed reading with the ignition switch on and the kill switch pulled out, it can be either of these causing the problem.

[Joker2]

I'll try thanks

[Joker2]

Spent 3.5 hrs tonight We lost the battle. My friend ( aircraft mechanic ) who is an avid boater came with his meter tonight to test my emergency kill switch, we read it was bad and changed it, tried to start it still no spark, ran motor the other day by pulling apart the Black / yellow plug by powerpack. Today after we changed kill switch we did the same thing, no spark. I'm goin' nuts.Could it be a bad ignition switch?