Lifting Johnson OB

[Skools Out]

i made my own OMC lifting hook that actually fits my Merc 150 as well. i had a comealong go bad so i chop sawed it up and made a motor lifting eye out of it. been using it for about 10 yrs now. works great. i used the end of the comealong that would rotate so i can spin the motor on the hook plus tilt it.

[jasoncooperpcola]

Ferm the 5/16x24 is a perfect fit, you saved me alot of trouble trying to figure out the treads! Lowe's does not sell fine thread 5/16 Grade 8 bolts, i used Grade 5 instead. They came in a pack of four so i said, what the hell lets use all three holes in the flywheel.

I got it hanging back on the transom temp for now. I couldn't get my bracket trimmed all the way down so i had hell getting the bolts back thru. Ended up using a ratchet strap on the cavitation plate to my lifting bar to angle it correctly.

I appreciate everybody's help! Now i know how to get her off when i find my new motor.

[Destroyer]

Originally Posted by Skools Out

i made my own OMC lifting hook that actually fits my Merc 150 as well. i had a comealong go bad so i chop sawed it up and made a motor lifting eye out of it. been using it for about 10 yrs now. works great. i used the end of the comealong that would rotate so i can spin the motor on the hook plus tilt it.

I was thinking of making my lifting plate on the lathe, and then threading the center hole to the same size threads as the outside threads of the merc tool... that way if I wanted to lift the merc I could just do it normal, but to lift the OMC I'd just thread the Merc lifting device into the centerhole in the plate, thread the 3 bolts thru the holes and into the flywheel and I should be good to go. I use a cherry picker, but I like your idea of the swivel hook for rotating the engine. I think I'll get one and put it on the short length of chain on the picker. Hopefully I'll never have to use it..

[jetblue319]

I know its been a while since this last post, but have you taken your 85 johnson outboard 150 apart? i have to tear down this engine i have just womdering if you have any input on removal. i have the service manual,
thanks jet

[reelapeelin]

Originally Posted by jetblue319

I know its been a while since this last post, but have you taken your 85 johnson outboard 150 apart? i have to tear down this engine i have just womdering if you have any input on removal. i have the service manual,
thanks jet

Jet...suggest you start a new thread for this question...sometimes hanging a new question on the end of an old thread gets lost...if you have the manual it should go fairly easily...except for if you have frozen bolts...

[jasoncooperpcola]

I have not taken it apart. Its on an 18 Fish as of yesterday for demo so i can run it for buyers. All i can say is PB Blaster is your friend.