dash panel

[ssiredfish]

I used Starboard on mine and I think it came out fine. Would of loved to have it angled up a tad more though.....

Look at second pic......
http://www.wellcraftv20.com/communit...ad.php?t=16103

[phatdaddy]

this is one made from ipe, similar to teak. vic,fellow member, made for me.

[spareparts]

kinda hard to see, but I made this dash with black plexi, I cut out all th holes and made the screw holes before I peeled the paper off. Then i sanded the edges smooth, ran across the edges with a propane torch(it work real good) to give it that finished look. I painted teh back side with black paint to make it look better

[reelapeelin]

Here is a '74 redo I did w/1/2" Starboard back in 1999

And a '95 V21 of 1/4" Starboard from last year...




If you are handy at all w/tools, it's not that daunting a task, but if you are looking for a super sharp factory quality dash panel, there is a contact in our Links section for one that can do it for you...

[stuarbc]

Here is the dash i had laser cut.....it was a guy i found off of classic-mako.com

[RWilson2526]

Originally Posted by stuarbc

Here is the dash i had laser cut.....it was a guy i found off of classic-mako.com

Ahh....thats the one I was referring too.....That does look sweet....how much did it cost you if you dont mind me asking?

[SkunkBoat]

When I got a new motor with a single gauge, I removed the old cracked plastic dash and threw it away. Replaced with black 1/2" starboard. Replaced all switches with a new switch panel.

If you can use a saw, a router, and a drill, or know someone who can, its a snap.

Measure three times, think about it again, measure again, cut once....

[msbhammer]

Starboard and a router, and you be set to go. Good luck.