|
|
|
|
#1
|
||||
|
||||
Absolutely....like Destroyer said thats the way most do it....There was a guy on here that sponsored for a while that made custom setups with the Wellcraft logo and all....somebody here had one made and it looked awesome. I'll see if I can find but you can try a search....depending on what kind of tools you have you could spend a ton of money if you need to go out and buy hole saws and mandrels and all. I personally like black plastic by the way for a dash instead of white.
__________________
1986 V-20 1986 Yamaha 150 HP 
|
|
#2
07-13-2011, 02:46 PM
|
||||
|
||||
|
I used Starboard on mine and I think it came out fine. Would of loved to have it angled up a tad more though.....
Look at second pic...... http://www.wellcraftv20.com/communit...ad.php?t=16103
|
|
#4
07-13-2011, 06:41 PM
|
||||
|
||||
|
kinda hard to see, but I made this dash with black plexi, I cut out all th holes and made the screw holes before I peeled the paper off. Then i sanded the edges smooth, ran across the edges with a propane torch(it work real good) to give it that finished look. I painted teh back side with black paint to make it look better
|
|
#5
07-14-2011, 06:33 AM
|
||||
|
||||
|
Here is a '74 redo I did w/1/2" Starboard back in 1999
 And a '95 V21 of 1/4" Starboard from last year...   If you are handy at all w/tools, it's not that daunting a task, but if you are looking for a super sharp factory quality dash panel, there is a contact in our Links section for one that can do it for you...
__________________
'74 V-20/ BF 150 '95 V-21/ BF 150 '84 V-20/ 200 2.4 Merc '87 V-20/'18 F150 Yamaha 
|
|
#7
07-15-2011, 10:09 AM
|
||||
|
||||
|
Quote:
Ahh....thats the one I was referring too.....That does look sweet....how much did it cost you if you dont mind me asking?
__________________
1986 V-20 1986 Yamaha 150 HP
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
