Engine flush kit

[tsubaki]

Hope I understand your questions.
It's designed to flush the engine without the need to run the engine.
It's two piece, made of plastic. One piece replaces your factory pisser, during flushing the other piece screws on the end of a hose and then plugs into the new pisser. Easy, quick, quiet flush.
Just be sure to align the new pisser to the direction you prefer, might have to use Teflon tape if it don't tighten to the direction you want.
If you want to run the engine when it's out the water, just use muffs.
Here is their site location of the flush kits.
http://www.thmarine.com/product.cfm?PRID=179

[tsubaki]

I think I understand now.
You may want to flush the engine when the boat is in the water and tilted up?
No problem, just don't run the engine.

[THEFERMANATOR]

With a carbed engine you won't be able to run it with the engine tilted up as the fuel in the bowls will be running all over the place with it running. Also I don't reccomend flushing it using the flush port with the engine trimmed all the way up as it can let water run back into the powerhead through the exhaust in some instances.

[willy]

All right with this set up when I come back from running, shut down the motor. Keep it trimmed down and even though the lower unit is in the water it will flush the engine? Right?

[THEFERMANATOR]

Originally Posted by willy

All right with this set up when I come back from running, shut down the motor. Keep it trimmed down and even though the lower unit is in the water it will flush the engine? Right?

Yes, or use a pair of pliers and unthread teh pisser plug and thread your hose in that way. You can trim the engine up out of thewater, but I wouldn't trim it up all the way if it was mine.

[willy]

got ya, thanks guys I am going to order a new pisser!

[bradford]

Originally Posted by willy

got ya, thanks guys I am going to order a new pisser!

Maybe you should let the wife pick one out.