![]() |
|
|
|
#1
|
||||
|
||||
|
awthacker, please refresh my memory.
I had it in my mind you had cleaned the tank, replaced the fill hose and the fuel lines to the motor and added the water separator prior to or during your repower.
__________________
'75 Cuddy with '00 Johnson Ocean Pro 150 horse Benny |
|
#2
|
||||
|
||||
|
There was a thread a couple of years ago when Hammer had this same problem.
His ball would get soft and he'd have lefty squeeze it and it would get hard again. LOL!! ![]() Where's old Hammer been? I miss him.
__________________
1985 Wellcraft V-20, Evinrude ETEC 150: SOLD 1979 Marine Trader 44, twin Ford Lehman 120s 2006 Panga 14, Tohatsu 20 |
|
#3
|
||||
|
||||
|
Cleaned the tank, replaced the fuel lines, left the primer bulb because it looked new, did not replace the fill hose or air vent hose, replaced water seperator.
|
![]() |
| Thread Tools | |
| Display Modes | |
|
|