|
|
|
|
#1
|
||||
|
||||
Hit a snag:
I got a e mail from the guy on ebay and he said he doesn't have any repair kits to fit my cyl's. He said he's never tried to find the kits for my stuff. Now the decision comes to try to get mine apart and see if I can find the seals and o rings or bite the bullett and buy cyl's. I wonder if the newer style cyl that he has would fit mine?
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson  
|
|
#2
11-30-2010, 07:05 PM
|
||||
|
||||
|
Took some pics of additional disassembly but I'm having trouble with login for photobucket so until they get my login fixed I wont be able to post pics.
I could open a new account but then I would lose all my pics stored on there. It may come to that. 1 of the pics I took shows a plastic allen head fastener (outdrive side) next to the hyd cyl pin that holds the hyd cyl (trim hyd cylinders) to the transom shield. Does anyone know what it's for? Also the hyd cly pin is threaded partially and has a bolt in it (is inside the boat) does anyone know how these pins are removed? The Seloc book doesn't address my type of attachment.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson
|
|
#3
11-30-2010, 10:23 PM
|
||||
|
||||
|
thats a 290 drive right? I'll see if i can get a factory manual
|
|
#6
12-01-2010, 07:59 PM
|
|||
|
|||
|
Lee, If you can get the cylinder head, rod and piston assembly out of the cylinder barrel you can take it to Hydraulic Service on Victory Blvd in Portsmouth Va. Im pretty sure they could fix you up with a repair kit. Give them a call at 757-487-2513 or toll free at 1-800-537-9986. I use to carry all kinds of cylinders to them and they have always fixed me up.
__________________
 77 V20 cuddy with 170 I/O Mercruiser 72 16ft. Carolina w/a 25hp Evinrude
|
|
#7
12-02-2010, 08:33 PM
|
||||
|
||||
|
Thanks C
If Tony at Shoreflythe is correct the only way to get the connecting pins (that hold the cyl to the transom shield) is to push them outboard with high pressure grease. If you look at the 2 pics that show the yellow dots, they get removed and then the grease fittings are exposed. He said they could be very hard to get out. Tony said he had found o rings and seals to fit them but he didn't sound like he would sell them to me or install them in mine ( I think he wants to do the removal and reinstallation) If I can get them out I was planning to go to a hyd shop and try to find the o rings and seals but I may see if Tony will sell them to me. Spare was looking to see if he could find a manual on mine. My Seloc repair manual doesn't address my type of connection.
__________________
Tis better to be quiet and thought a fool than open your mouth and prove it!! 1991 V-20 cuddy I/O 350 volvo duo prop, 1998 15ft Grumman 9.9 Johnson
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
