|
|
|
|
#1
|
||||
|
||||
You are too generous NYMack. It don't look good but it will work. Destroyer had me worried about penetration so I turned it up. I made two passes with the 7018 rod after tacking the spindle in place. The spindles came in slightly different than what was there. The weldable end had been turned down with a lathe to fit inside the square tubing but the turned down portion was 3/4" longer than original so instead of just placing the spindle into the square tube until it stopped at the part of the spindle that wasn't cut down (like a flange) I had to pull the spindle out 3/4" on each side and was welding to the part that was turned down. I pinned the spindle into a corner of the axle tube which made the opposite side a sloppy fit so two passes. BTW- boat shoes should never be worn while welding.
|
|
#2
09-13-2010, 09:29 AM
|
||||
|
||||
|
Quote:
 It looks good Ridge.. nice job. Well done!! 
__________________
1987 V20 w/1987 150HP Yamaha on a Shoreland'r Trailer 1978 16.5 Airslot w/1996 120HP Force on a Four Winns trailer 1996 V21 w/1993 200HP Mercury on a Shoreline Trailer All towed by a 5.7L Hemi Durango. If God didn't have a purpose for us we wouldn't be here, so Live simply, Love generously, Care deeply, Speak kindly. (Leave the rest to God)  Silence, in the face of evil, is itself evil. Not to speak is to speak, not to act is to act. God will not hold us guiltless.
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Hybrid Mode
