new to forum - my V-20 project

[BRIELLY]

Originally Posted by nepatsfanatic

Did you do all the work from the cap access? I've seen a few different ways done nice, and successfully, I think I'll be okay doing the work from outside by removing the outer skin if I need too. I would be grateful for any pointers as to where to cut, more importantly where not to cut!, wish me luck! Steve.

I rented the longest chainsaw I could get, pulled off the aluminum cap and and started cutting. About 8 hours later it was ready to be filled. If you do the other method avoid cutting the outside skin. Professionals cut the rear section of the cap off and replace the wood and skin from the inside.